How to Use Instructions: FootFitter Premium Professional Shoe Stretcher 2-Way Deluxe
Directions For Use: Using the FootFitter Premium Professional Shoe Stretcher 2-Way Deluxe can stretch your shoe at all pressure points. In addition, your shoe’s length can be stretched to a certain extent. Due to its straight design, the stretcher can be used on a left or right shoe. Stretch the length, width, or both at the same time.
B. Heel Section (Back Piece)
C. Larger structured wheel (turn counter clockwise to extend stretcher in length)
D. Black Handle (turn clockwise to spread the stretcher out)
E. Corn pieces (different sizes can be fiited into holes of the toe section (A))
Step 1: Before using the FootFitter Premium Professional 2-Way Shoe Stretcher, we strongly recommend treating the shoe with a shoe stretch spray, dampen it with water, or steam to soften the leather in the areas in the areas you intend to stretch.
Step 2: The toe section (A) of the stretcher is fitted with various holes. One of the movable corn pieces (E), which differs in size, can fit into one of the holes, exactly where the pressure point is located. If there are several pressure points, several movable corn pieces (E) can be used during on stretching process.
Step 3: Before carefully inserting the FootFitter Premium Professional 2-Way Shoe Stretcher into the shoe, it is advisable to turn the large silver structured wheel (C) clockwise so the back section (B) of the stretcher will be near to the front section (A) as possible. NOTE: Make sure that the front section (A) of the FootFitter Premium Professional Shoe Stretcher 2-Way Deluxe is not spread out, by turning the black handle (D) counterclockwise.
Step 4: Insert the FootFitter Shoe Stretcher carefully into the shoe. Turn the large silver structured wheel (C) counterclockwise and the heel section (B) of the stretcher will be gradually moving towards the heel of your shoe. By doing this, a certain resistance will soon be reached and the shoe will be stretched in length. NOTE: Do not overstretch! Excessive stretching causes damage to the material of your shoe. Repeat the stretching process if necessary.
Step 5: Once the desired length is reached, the black handle (D) can be turned clockwise. The stretcher will then slowly widen the shoe. Until the stretcher and shoe feel snugh, turn it about 2 – 3 more times for good measure.
The FootFitter Shoe Stretcher should remain in the shoe for at least 48 hours.
To remove FootFitter Shoe Stretcher turn the large silver structured wheel (C) clockwise and the black handle (D) counterclockwise.
Download PDF Version
Kugo Inc., 930 West 16th Street Unit C-2, Costa Mesa, CA 92627